Nonylphenoxypolyethoxyethanol-Iodine Complex..... 5.00%
(Provieds 1.0% minimum Titratable Iodine)

INERT INGREDIENTS:
Glycerine ................................................................... 2.00%

Other Inerts ............................................................ 93.00%

TOTAL: ................................................................... 100.00%
pH of 5.5 at the time of manufacture
This product contains highly effective levels of
free iodine for fast kill of mastitis causing organisms.

1. Use teat dip applicators made of plastic or other non-corrosive materials. Do not use cups made of aluminum.
2. When solution in the teat dip cup becomes dirty and/or noticeably loses color, discard remaining contents and refill cup with fresh teat dip.
3. Do not use this product for cleaning or sanitizing equipment.
4. Wash teat dip cups after each milking.

KEEP OUT OF REACH OF CHILDREN

Do not dilute this product.

Do not return teat dip left in the teat dipper to storage container.

Ensure that teats are dry before exposing the animals to weather conditions which may cause damage to the teats.

Protect this product from freezing.

EYE CONTACT: IMMEDIATELY FLUSH EYE WITH LARGE AMOUNTS OF FRESH, TEPID WATER FOR 15 MINUTES. HOLD EYELID OPEN TO ENSURE COMPLETE IRRIGATION OF EYE AND LID TISSUES. TILT HEAD TO THE SIDE AND IRRIGATE THE EYE FROM THE BRIDGE OF THE NOSE TO THE OUTSIDE OF THE FACE.
SKIN CONTACT: FOR READY-TO-USE PRODUCTS, WASH ANY SENSITIVE AREAS.
INGESTION: DO NOT INDUCE VOMITING. NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON. DRINK LARGE AMOUNTS OF WATER. IF VOMITING OCCURS KEEP AIRWAYS OPEN. KEEP HEAD LOWER THAN THE HIPS TO PREVENT ASPIRATION INTO THE LUNGS.

NOT FOR HUMAN USE.

ALWAYS SEEK IMMEDIATE MEDICAL ATTENTION

FOR MEDICAL EMERGENCIES CALL 1-800-424-9300

A. PRE-MILKING (PRE-DIPPING)
1. Remove visible soils from the teats.
2. Observe formilk by stripping two or three streams of milk into a strip cup.
3. Dip or spray the cow's teats full length with FS-103 II Teat Dip.
4. Wait approximately 30 seconds.
5. Remove all teat dip by thoroughly drying the teats and teat orifices with a clean, single service paper towels(s).
6. Attach milking unit.
B. POST-MILKING (POST-DIPPING)
Immediately after milking, dip or spray all teats full length with FS-103 II Teat Dip. Ensure good coverage of all sides of the teats and teat orifices.

FS-103 II